This patch adds a new flag to iproute2 for vxlan devices to enable
DOVE features. It also adds support for L2 and L3 switch lookup miss
netlink messages to "ip monitor".
Changes since v2: fix merge conflict
Changes since v1:
- split "dove" flag into separate feature flags:
- "proxy" for ARP reduction
- "rsc" for route short circuiting
- "l2miss" for L2 switch miss notifications
- "l3miss" for L3 switch miss notifications
Signed-off-by: David L Stevens <dlstevens@us.ibm.com>
When running 'ip monitor neigh', there is no hint to tell if a neighbor is
updated or deleted.
Signed-off-by: Nicolas Dichtel <nicolas.dichtel@6wind.com>
New "ip neigh show proxy" command now can show proxies which
were added with "ip neigh add proxy" command. Kernel code to
support this feature sent a bit earlier to netdev.
Signed-off-by: Tony Zelenoff <antonz@parallels.com>
Both rtnl_talk and rtnl_dump had a callback for handling portions
of netlink message that do not match the correct pid or seq.
But this callback was never used by any part of iproute2 so remove
it.
On tis, 2008-07-22 at 20:21 +0200, martin f krafft wrote:
> piper:~|master|% sudo ip a flush dev eth0 >/dev/null
> Nothing to flush.
>
> It should just shut up, shouldn't it? :)
The patch below makes the "Nothing to flush" only visible when show
statistics flag is given, and then only to stdout rather then stderr.
$ sudo ./ip/ip -s addr flush dev skif
Nothing to flush.
$ sudo ./ip/ip addr flush dev skif
$
(See http://bugs.debian.org/492196 )
Some usages of rtnl_send could cause errors (ie flush requests)
others do a listen afterwards.
Signed-off-by: Stephen Hemminger <stephen.hemminger@vyatta.com>
In order to support these new flags add current
linux/if.h into the directory with the local copies.
This caused troubles with outdated redefinitions from net/if.h
so I've removed the dependency on it.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
addresses. Specifically it does not correctly handle the addition of
new entries in the neighbor/arp table. For example, this command will
fail:
ip neigh add 192.168.0.138 lladdr
00:00:04:04:fe:80:00:00:00:00:00:00:00:01:73:00:00:00:8a:91 nud
permanent dev ib0
An IPoIB link layer address is 20-bytes (see
http://www.ietf.org/internet-drafts/draft-ietf-ipoib-ip-over-infiniband-09.txt,
section 9.1.1).
The command line parsing code expects link layer addresses to be a
maximum of 16-bytes. Addresses over 16-bytes are truncated.
Stephen Hemminger
David L Stevens
Nicolas Dichtel
Stephen Hemminger
Tony Zelenoff
Stephen Hemminger
Andreas Henriksson
Thomas Graf
Stephen Hemminger
shemminger
osdl.net!shemminger
net[shemminger]!shemminger
5!tgraf
ch[shemminger]!tgraf
osdl.org!shemminger